Flowmaster U-Fit Dual Kit - Making It Fit - Tech
|
Once the collectors are bolted up, the next step is to locate your crossover, or X-pipe. You'll want to make sure you mock it up as high as you can because these first steps are going to determine how low the system is going to hang. In this case, the job's a bit easier because Josh is working under a lift rather than laying on his back in the driveway-but, if you're on the floor you can block this piece up with a few scraps of 2x4 or whatever's handy. This may be a good time to mention that you'll be doing a fair amount of trimming on the various pieces of pipe as you go. View Related Article
|
|