Flowmaster U-Fit Dual Kit - Making It Fit - Tech
|
With the collectors attached and the crossover pipe mocked into place, it's then time to make the connection between them. Grabbing the next pieces of tubing (from those that you laid out on the floor you can then hold them up between the collector in the front of the crossover, make your marks on the tubes, and trim them to fit). If you're going with the slip-fit and clamps route make sure you make your marks and cuts at the ends of the tubing that aren't expanded. Also remember that each slip-fit connection can be rotated to allow for a wide variety of paths for the system. If you're welding it together, go ahead and mark and cut the tubing where appropriate. View Related Article
|
|