Patina Paint Job - Turning Back Time

Schmidt continued wet sanding around the exterior corners of the roll pan, using extra effort to break through in certain areas, and bring the patina to its proper level.

With the wet sanding completed, Schmidt washed the roll pan with clean water followed by blowing the surface off and drying it with a soft white cloth. After inspecting the panel, he used a maroon scuff pad to remove any remaining sanding scratches and give the paint surface a nice balanced texture.

Noting that the paint surface is still soft, care must be taken with the pressure applied when using the scuff pad. The flexibility of the pad allows all of the tight contours plenty of attention, especially in the louvered areas. Once completed the area was blown clean.

Working in a circular and left to right motion with just enough water to break down the Comet, Schmidt masterfully works the surface to cut down just a bit more of the paint surface.

Once completed, the entire panel is washed clean with clear water and a soft bristle brush to be sure the Comet is finally removed.

Looking at the final product proves that you can step back in time to create a unique paintjob that will leave your hot rod looking like it has gracefully aged over the last few decades.

Signature to all of the hot rods built by Rolling Bones, their patina'd paint finishes will only get better with age. It takes great attention to detail to bring the appearance to this level.

Even the chassis and suspension components were treated to the custom finish artfully illustrating where normal wear and tear would take place.