|
|
 This rubber seal was attached...  This rubber seal was attached to the inside opening of the outer trim ring by four wire retainer springs to provide a snug fit between the bezel and the headlamp.  Fitting the retainer springs...  Fitting the retainer springs in the rings takes a little manual dexterity, a little patience, and a little luck, but once they're in, they'll stay in.  The last step will be the...  The last step will be the wiring, which will be done when the electrical system is installed.  The outer trim ring was mounted...  The outer trim ring was mounted with a single screw at the bottom.  Project Shop Truck now has...  Project Shop Truck now has headlamps. Nothing to do now except wait for it to get dark.  That was easy, but we're not...  That was easy, but we're not done yet. We still have a front bumper to install.  All you need for the job is...  All you need for the job is a re-popped bumper from Chevs of the 40's, a pair of Y-style bumper brackets, mounting hardware, and a truck to mount it to.  The easiest procedure is to...  The easiest procedure is to mount the bumper to the brackets and the brackets to the frame. The smartest way is to trial mount the brackets on the frame first to make sure everything lines up right. Each bracket mounts to the 'rails with three bolts.
|